RC car parts and setup

Before you choose

Compare the details that matter, then check the full product page.

Slick touring wheel set →

1:10 touring; 12 mm hex, 64 mm outer diameter, 26 mm width.

Inspect glued edges and wheel seating before each run.

1:10 touring; 12 mm hex, 64 mm outer diameter, 26 mm width.

Remove grit after use and inspect for splits.

12 mm outer hex; 4 mm axle bore; check pin and wheel clearance.

Tighten correctly and inspect for wear after running.

1:10 touring; 190 mm width and 257 mm nominal wheelbase. Trimming required.

Use polycarbonate-compatible paint; handle trimmed edges carefully.

Match clip wire thickness and post hole before ordering.

Discard bent clips; keep small parts away from children.

Metric socket screws only; verify size before applying torque.

Wipe dry and replace worn tips.

For low touring-car chassis with 3–10 mm clearance.

Keep contact faces clean; do not force under the chassis.

Model workshop surface; keep heat sources and solvents away.

Wash with mild soap, rinse and dry.